![]() It is recommended to run the mixer on speed 10 for 2 minutes in order to redistribute oil back into the motor. Oil leakage may primarily be seen from around the beater shaft or planetary action.Ī stand mixer can lose up to a 1/4 cup of oil before it needs to be serviced. If the motor sits idle for some time (is not used), the oil may begin to drip from the gears and settle. Kitchenaid stand mixers are overpacked with oil to last the lifetime of the motor. Your Use and Care Guide will cover the "beater to bowl adjustment," which you can do at home in a few minutes with a flathead screwdriver.Īlso, leaking of oil in a stand mixer is not necessarily indicative of a large problem. If the flat beater is striking the bottom of your bowl, this may cause the locking mechanism to loosen and may cause the mixing head to "bounce" during use. The "wobbling" sounds like an issue of beater to bowl adjustment, which can come out of alignment naturally over time and with use of the machine. 4) Lastly, you may want to readjust the large screw controlling the head's tilt to optimize the distance between attachment and bowl. ![]() Your wobble should be greatly reduced or eliminated now. 3)Tighten the small set screw as much as you can. Note that this screw is not the large slotted screw I mentioned earlier visible when you tilt the head back. This screw actually presses against the pin and takes up the slop between the head and pin. 2) Looking deep into the hollow base, find the small slotted set screw. To "tighten" the sloppy tolerances causing your wobble, follow these steps: 1) Lock the mixer's head down and turn the entire mixer upside down. Any play between the head and base comes from this hinge and its resulting tolerances. The head of the mixer is secured to the base by a large steel pin. In fact, the wobble may be causing the bowl strikes and adjusting the head height only hides the problem. Although the attachment striking the bottom of the bowl will lead to wobble (and noise!), it isn't usually the root cause of the wobble. By adjusting the screw located at the junction of the head and base, you are actually controlling how far the head is allowed to tilt forward and, thus, the height of the attachment above the bottom of the bowl. The solution provided by luannej is useful only if your mixing attachment is striking the surface of the bowl.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |